SPECIFICATIONS: Pro Drain Chief II (Low Speed) by Viking InjectorDIMENSIONS: 7" X 7" w X 6 1/2DENCLOSURES: Input: 120 VAC, 5 Amps, 60 hrz. Power Cord attached to unit (Optional Battery - powered unit available)PUMP: Peristaltic type using 1/4" ID Squeeze tubing Maximum lift - 20 ft vertical Maximum PSA - 40 lbs. Feed Rate (low speed) - 4.5 ft. oz. (133 ml.) per minute with 6 1/2 foot lift and psuh Minimum injection - 1.5 fl. z. ( 44 ml.) @ 20 second run time Maximum run time - 3 minutesPROGRAM TIMER: 24 hour repeat cycle - 1 minute activation interval (optional 7 day timer available)MOUNTING: Wall mount, double key (drilling template included) Surface mount: Rubber suction feet available
Complete installation hardware and instructions included
Security lock with key
Heavy-duty lid hinge
INSTALLATION: DrainMaster APPLICATIONFEATURES:Follow manufacturer's installation instructionsTo install a DrainMaster 5-gallon pail1. Remove safety cap from spout on lid of pail2. Remove black, screw-on resealing cap3. Pull ring and remove innner spout cap4. Locate ring of plastic on spout5. Using a sharp knife cut spout just below the ring6. Break apart the three sections of snap-together dip tube and snap sections together to make a single 17 5/8 tube.7. Push the assembled tube through the spout, slotted end first (slotted end goes to the bottom of pail, flush side protrudes approximately 3" above the pail lid. This will fit tightly.8. Insert square plastic piece with compression fitting into protruding end of dip tube.9. Connect one end of tubing to dip tube compression fitting and other end to compression fitting on supply side of pump.